This series of network management optical transceiver rack absorbs the advantages of similar products at home and abroad, and the product is more flexible and practical. The network management optical transceiver adopts a flexible rack modular design, consists of a 16-slot 2U chassis, power modules, and standard hot-swap modules. The built-in chassis contains dual fault-tolerant power supplies and passive backplane buses to ensure high system reliability. The optical transceiver of the network management system has a unique watchdog design. When the device runs abnormally, it can automatically restart the device to ensure unblocked lines.
Product features:
In the master-slave architecture, a management module (master and slave) can be cascaded to a maximum of four chassis for management
The failure of the management module does not affect the normal operation of other modules.
It supports graphical and command line management based on SNMP, Telnet and Web.
NMS ports: RS232 Console Port (RJ45) and 10/100 MBPS RJ45 Ethernet Port
You can display and configure complete system information, including rack names, region information, IP address information, and software and hardware versions
The business module can be unified management and status query, greatly reducing the procurement cost
Gigabit and 10-gigabit transceivers and Repeaters support SFP, CWDM SFP, DWDM SFP, display SFP information and digital diagnosis functions
The transceiver card supports the Q-in-Q Double Tag VLAN, IEEE802.1q Tag VLAN, and IEEE802.3x Flow control protocols
You can query detailed information about the power supply and chassis temperature and report faults.
You can query and configure the working mode of each port on the local and remote devices, including connection status, connection rate, full/half duplex, port off, and LFP
Port speed limiting function, 100 Mbit/s transceiver 32Kbps step in 0Mbps to 100Mbps, gigabit transceiver 64Kbps step in 0Mbps to 1000Mbps bandwidth arbitrary Settings
Supports link speed Loopback, facilitating line debugging
Supports remote power failure detection. The optical fiber connection status of the sending end can be detected by remote error signals sent by the peer end
Supports failover (LFP) to quickly locate the link where the fault occurs, facilitating maintenance personnel.
The SNMP network management protocol is supported. You can set Trap Destination, Community Name, and corresponding permissions to receive and display alarms using SNMP traps in real time, and provide a dedicated monitoring window in which alarms, audible alarms, and email alarms can be displayed
Provides MIB library files and supports software such as OpenView and Snmpc
You can query and manage historical alarms and logs
It has the function of traffic statistics and early warning, and can display the communication status of each port in real time
Supports remote restart. You can restart the system or a module using the network management software
User management adopts the hierarchical management mode (including common users, advanced users, and administrators) and has the authentication function
You can restore the factory Settings of the transceiver board or the DIP switch configuration. After a power failure, the configuration information is automatically saved. The transceiver board can be configured as an office or remote end using the DIP switch
Supports FTP online remote upgrade
The network management system automatically discovers and adds network devices.
The centralized management mode, combined with the tree directory, can simultaneously manage multiple rack devices in one software interface; At the same time, the group management mode is introduced to enhance the level of management. Even if many devices are managed at the same time, it is convenient to operate any device.
